Bradal Before editing a nav line it must bedisabled. Roll the scrollwheel to adjust tuning. The screen shows the bearing scale anddigital timer approximately 30 seconds ffa power-on. Use the scrollwheel to enter nav line number to edit. Enter expected course andspeed and delay time until start of a maneuver and the expected position of yourship and tracked targets at the end of the trial maneuver are shown on thedisplay. Tell us about it.
|Published (Last):||6 October 2018|
|PDF File Size:||18.75 Mb|
|ePub File Size:||8.15 Mb|
|Price:||Free* [*Free Regsitration Required]|
Those items contain organic solvents that can damage coating and plastic parts, especially plastic connectors. Antenna Units 1. Page 8 1. The coax. Separate this antenna from other VHF radiotelephone antennas as shown on the next page to prevent interference to the FA Page 10 1. How to attach the plug M-P-7 Lay the coaxial cable and attach an M- 30 mm type plug if necessary to the cable as Sheath follows.
Page 11 1. Dismount the bottom cover, cut the cable-tie inside the unit and take out the co- axial connector attached to the combined box. Loosen four screws to loosen whip antenna fixture and pull out the coaxial con- nector coming from the combined box through the hole in the whip antenna fixture. Page 12 1. Fix the distributor unit on the bulkhead, facing the cable entrance downward. Page Monitor Unit 1. Install it on the chart table or near the steering place, referring to the outline drawing.
Page 14 1. Name Type Code No. Page Uais Transponder 1. This unit can be installed on a bulkhead. Install it, referring to the outline drawing.
FURUNO FA-150 FILETYPE PDF
Furuno FA-150 Operator's Manual
Furuno FA-150 Installation Manual